To ensure the best experience with OUXI GT2000 electric dirt bike, please read below GT-2000 display manual carefully before use. We provides step-by-step instructions—from installation and display setup to daily operation. It also helps you quickly resolve common issues and get the most out of your ride.
GT-2000 NFC Display Installation
Mount the Display: Open the clamp, place it at the center of the handlebar, and tighten the screws with an M3 hex key.
Torque: 0.8 N·m (Over-tightening not covered by warranty)
Connect the Cable: Align and plug the 5-pin connector from the display to the controller.
0–9 mode / 1–9 mode (“0” means includes level 0 assist; “1” starts from level 1) P06 – Wheel Diameter: in inches, accuracy 0.1 P07 – Speed Sensor Magnets: Range 1–255 P08 – Speed Limit: 0–100 km/h (±1 km/h accuracy)
Note: Speed values are based on km/h. When units are switched to miles, displayed speed adjusts automatically, but the limit value itself does not convert. P09 – Start Mode: 0 = Zero Start; 1 = Non-zero Start P10 – Drive Mode: 0 = Pedal assist only 1 = Throttle only 2 = Pedal assist + throttle (throttle disabled in zero start) P11 – PAS Sensitivity: Range 1–24 P12 – PAS Start Strength: Range 0–5 P13 – PAS Magnet Type: 5, 8, or 12 magnets P14 – Controller Current Limit: Default 15A, range 1–20A P15 – Low Voltage Protection Value P16 – Odometer Reset: Hold the UP button for 5 seconds P17 – Cruise Control: 0 = Off, 1 = On (optional)
How to Make OUXI GT-2000 Faster
GT-2000 Electric Dirtbike Speed Setting
OUXI GT2000 Error Code
E00: Normal operation
E02: Brake activated
E05: Overvoltage protection
E06: Undervoltage protection
E07: Motor Hall sensor error
E08: Throttle fault
E09: Controller fault
E10: Communication error
E16: Ignition short circuit
E21: Controller overcurrent
User Notes & Safety Tips
Power Safety: Do not plug or unplug the display while the power is on.
Avoid Harsh Conditions: Try not to use the display in heavy rain, snow, or under direct sunlight.
Handle with Care: Avoid impacts or drops.
Waterproof Protection: The display comes with a waterproof film (IP6 rating). Do not remove it, or it may affect waterproof performance.
Parameter Settings: Do not change advanced settings without guidance, as it may cause malfunction or riding issues.
Maintenance: If the display malfunctions, send it for repair promptly.
Asen asenof asan01978@abv.bg greska 35 nova Zagora ekon
My throttle goes only 6kmh how do i take te speed limiter off the throttle in the console